Checking The Updated Settings - Hitachi XP P9500 User Manual

3
4
5
6
7
Table 3-5 Values Indicating Audit Log Data Categories on page 3-12
describes the values that indicate audit log data categories. The default is
all.
Value
ss
a
ca
all
This example shows how to enable the collection of audit log data:
>dlnkmgr -l set -audlog on -audlv 6 -category all
Specify on if you want to collect audit log data, and off if you do not want to
collect audit log data. If you specify on, you can use the -audlv parameter to
specify the collection level for audit log data and the -category parameter to
specify the audit log categories.

Checking the Updated Settings

This chapter describes steps involved in how to check the new settings by
using the dlnkmgr command's set operation after the new settings are
applied.
When you some these settings, you can display information about all of HDLM
function settings. The following is an example of executing the command:
>dlnkmgr -s host-name -u user-name -p password view -sys -sfunc
HDLM Version
Service Pack Version
Load Balance
Intermittent Error Monitor
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
>
3-12
Value (severity)
Table 3-5 Values Indicating Audit Log Data Categories
Audit log events of the StartStop category are collected.
Audit log events of the Authentication category are collected.
Audit log events of the ConfigurationAccess category are collected.
Audit log events of the StartStop, Authentication, and
ConfigurationAccess categories are all collected.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for VMware(R))
Explanation
Error-level and Warning-level audit log data is
collected.
Error-level, Warning-level, and Information-level
audit log data is collected.
Explanation
: x.x.x-xx
:
: on(extended lio)
: on(2/20)