Craftsman ZTS 7500 Operator's Manual page 6

Q
©
Figure 4. install Hitch Assembly, without Weights
A. Frame
B. Hitch Assembly
C. Washers, 3/8
D. Locknuts, 3/8
E. Capscrews, Hex, 3/8-16 x 1-3/8
F. Locknut, 1/2-13
G. Capscrew, 1/2-13 x 1-1/4
H. Drawbar
I. Washers, 11/32 x 1-3/4
HITCH & BAG SUPPORT
INSTALLATION
Hitch installation
1. Attach hitch assembly (B, Figure 4) to frame (A).
Secure with 3/8-16 x 1-3/8 capscrews (E), washers
(I), washers (C) and nut (D) as shown. Finger tighten
at this time.
2. Install 1/2-13 x 1-1/4 capscrew (G) through drawbar
(H) and tighten.
3. Tighten all hardware.
Bag Support installation
1. Set bag support tube (B, Figure 5) onto hitch assem-
bly post (D).
2. insert bag support posts (A) into hitch assembly
tubes (C). Make sure that support posts insert com-
pletely into tubes.
Figure 5. Install Bag Support
A. Bag Support Posts
B. Bag Support Tube
C. Hitch Assembly Tubes
D. Hitch Assembly Post