Eye Shields - Craftsman 152.241180 Owner's Manual

EYE SHIELDS (Fig. G)
1,
Remove both Eye Shield Assemblies from the plastic
bags and check to see that you have the following.
Eyeshield (qty. 2)
Lock Knob (qty. 2)
Spacer (qty. 2)
M6 Flat washer (qty. 2)
M6 x 80mm carriage head screw (qty. 2)
,
Assemble the eyeshield (C) to the Spark Arrestor
(A) inserting carriage head screw (B) through
Eyeshield, the Spark Arrestor, and the Spacer (D)
as shown. See Figure G.
.
Assemble the flat washer (E) and Lock Knob (F)
to the carriage head screw and tighten until the
Eyeshield remains in the desired position.
See Figure G.
Fig. G
D
B
E
C
WHEEL DRESSER (Fig. H)
1. Remove the Wheel Dresser, the plastic Support, and
the two #10-24 x 3/8" screws from the plastic bag.
2. Attach the plastic Support (A) to the top of the motor
housing with the two screws (B). See Figure H.
3. Assemble the Wheel Dresser (C) to the Support as
shown. See Figure H.
Fig. H
C
A
F A