Spark Arrestors - Craftsman 152.241180 Owner's Manual

A 12mm x 10mm openendwrench is provided for
mounting t heToolRestAssemblies andtheSpark
Arrestor A ssemblies. Aphilipsscrewdriver is not
provided tomount t heWheel D resser S upport.
Fig. E
E
._ : k_I ,
1, DO NOT assemble the Bench Grinder until you are
sure the tool IS NOT plugged in,
2, DO NOT assemble the Bench Grinder until you are
sure the power switch is in the "OFF" position,
3, DO NOT assemble the Bench Grinder until you are
sure the grinding wheels are firmly tightened to the
Bench Grinder,
TOOL RESTS (Figs. D and E)
The Bench Grinder is provided with two different Tool
Rests assemblies, The Left Side Tool Rest is entirely
flat, The Right Side Tool Rest is also flat,
1, Remove both Tool Rest Assemblies from the plastic
bags and check to see that you have the following.
Left Side Tool Rest
Left Side Tool Rest Support
Right Side Tool Rest
Right Side Tool Rest Support
5/16" Flat Washer (qty, 6)
5/16-18 x 5/8" Hex head screw (qty, 4)
Adjustment Knob (qty, 2)
2, Assemble the Tool Rest Supports (A) to the inside
surface of the Wheel Covers (B) with the flat
washers (C) and hex head screws (D) as shown,
See Figure D.
3, Assemble the Tool Rests (E) to the Supports (F)
with the flat washers (G) and Adjustment Knobs (H)
as shown. See Figure E,
4. Adjust each Tool Rest until its inside edge (I) is 1/16"
from the grinding wheel, Firmly tighten the hex
head screws holding the supports, See Figure E,
Fig. D
C
8
H
F
G
SPARK ARRESTORS (Fig. F)
.
Remove both Spark Arrestor Assemblies from the
plastic bags and check to see that you have the
.following.
Left Side Spark Arrestor
Right Side Spark Arrestor
1/4" Flat Washer (2)
1/4-20 x 1/4" Hex head screw (2)
,
Assemble the Spark Arrestors (A) to the inside
surface of the Wheel Covers (B) with the flat
washers (C) and hex head screws (D) as shown.
See Figure F.
3, Adjust each Spark Arrestor until the lower edge (E)
is 1/16" from the grinding wheel, Firmly tighten the
hex head screws. See Figure F,
Fig. F
B
D