Advertisement
minutes. When
battery pack reaches normal voltage
range, red LED shouldcome on.
If red LED does not come on after 30 minutes,this
indicates a defective battery pack and shouldbe
replaced.
After normal usage, a minimum of 1 hour of charging
time is required to fully recharge battery pack.
The battery pack will become slightlywarm to the
touch while charging.This is normal and does not
indicate a problem.
Do not place charger and battery pack in an area of
extreme heat or cold. It will work best at normal room
temperature.
Note: Charger and battery pack shouldbe placed in a
locationwhere the temperature is more than 50°F but
less than 100°F.
•
When batteriesbecome fully charged, unplug charger
from power supply and remove the battery pack.
LED FUNCTIONS
OF CHARGER
LED WILL BE ON TO INDICATE
STATUS OF
CHARGER AND BATTERY PACK:
•
Red LED on = Fast charging mode,
•
Green LED on = Fully charged and in trickle charge
mode.
•
Green LED on = When battery pack is insettedinto
charger, indicates hot battery pack or that battery pack
isout of or below normal temperature range,
•
Yellow and Green LEGs on = Deeply dischargedor
defectivebattery pack.
•
No LED on = Defective charger or battery pack,
,_k CAUTION:
To prevent damage to battery pack,
remove battery pack from charger immediately if no
LED comes on Return battery pack and charger to
your nearest Sears Service Center for checkingor
BATTERY PACK
SHOWN IN CHARGER
replacing.Also, if you are removingbattery pack from
charger and no LEDs are on, return both battery pack
and charger to your nearest Sears Servico Center.
Do not insertanother battery pack intocharger. A
damaged charger may damage a battery pack.
IMPORTANT
INFORMATION
FOR RECHARGING
HOT BATTERY PACK
When usingyour trim saw continuously,the batteries in
your battery pack will become hot. You shouldlet a hot
battery pack cool down for approximately30 minutes
before attempting to recharge. When the battery pack
becomes discharged and is hot, this willcause the green
LED to some on instead of the red LED. After 30 minutes,
reinsert battery pack in charger. If green LEO continuesto
remain on, return battery pack to your nearest Sears
Repair Center for checkingor replacing.
Note: This situationonly occurswhen continuous use of
your drillcauses the batteries to become hot. It does not
occur under normal circumstances.Refer to "CHARGING
BATTERY PACK" for normal rechargingof batteries. If
the charger does not charge your battery pack under
normal circumstances,return both the battery pack and
charger to your nearest Sears Repair Center for electrical
check.
IMPORTANT
INFORMATION
FOR RECHARGING
COOL BATTERY
PACK
If battery pack is below normal temperature range, the
green LED on charger will some on. Allow battery pack to
reach normal temperature, then the red LED willcome on.
Note: Refer to "CHARGING BA'I-FERY PACK" for
normal rechargingof batteries, if the charger does not
charge your battery pack under normal circumstances,
return both the battery pack and charger to your nearest
Sears Repair Center for electrical check.
CHARGER
)N INDICATES
FAST CHARGING MODE
GREEN LED ON AFTER FAST CHARGING
CYCLE, INDICATESFULLY CHARGED
"rERYPACK AND IN TRICKLE
CHARGEMODE.
4-1/2 in.
Fig, 2
_.YELLOWANDGREEN LEDSON INDICATESDEEPLY
DISCHARGEDOR DEFEC'nVEBATTERYPACK.
10
Advertisement
