Advertisement
SPINDLE
LOCK BUTrON
LOCK-OFF
BUTrON
TRIGGER
RIP
GUIDESCREW
(WING SCREW)
UPPER
BLADEGUARD
GUARD HANDLE
BEVELCUT
ADZu_TMENT
(BEVELADJU_FMENT
KNOB)
BASE
ASSEMBLY
RiP GUIDE
A
WARNING:
Do not allow familiaritywith your drill-
driver to make you careless, Remember that a
careless fraction of a second is sufficientto inflict
severe injury.
BA'rrERY
PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possibleproblems, Therefore,
you should charge it untillight on front of charger changas
from red to green.
Note: Batterieswill no: roach full charge the firsttime they
are charged. Allow several cycles (drillingfollowedby
recharging)for them to become fully charged.
CHARGING
BATTERY PACK
See Figure 2.
•
Charge battery pack only with the charger provided.
•
Make sure power supply Is normal household
voltage, 120 volts, 60 Hz, AC only,
9
BLADEWRENCH'J_
BLADEWRENGH
mmHEXKEY)
DEPTHOF
CUTADJUSTMENT
(DEPTH ADJUSTMENT KNOB)
Fig.1
•
Connect charger to power supply.
•
Place battery pack in charger aligning raisedrib on
battery pack with groove in charger. See Figure 2.
•
Press down1 o n battery pack to be sure contacts on
battery pack engage properlywith contacts in charger.
•
Normally,the red LED on charger will come on. This
indicatescharger is in fast charging mode.
•
Red LED shouldremain on for approximately1 hour
then the green LED will come on. Green LED on
indicatesbattery pack is fullycharged and charger is in
tricklecharge mode. Note: Green LED will remainon
untilbattery pack is removedfrom charger or charger
is disconnectedfrom power supply.
•
Ifboth yellow and green LED come on, this indicatesa
deeply dischargedor defective battery pack.
Allow battery pack to remain in charger for 15 to 30
Advertisement
