Light - GE Quick Set V Series Owner's Manual

Care and cleaning of the range.
Removable Warming Drawer/Lower Oven Drawer Pan fansome models)
NOTE:For models with on electric Never place, use or self-clean the drawer pan
warming drawer or lower oven drawer, in the upper oven.
before performing any adjustments, Warming drawer or lower oven drawer has a
cleaning or service,disconnect the range removable pan for easy cleaning. Cleanwith
electrical power supply at the household hot, soapy water and a sponge or dish towel.
distribution panel by removing the fuse or Dry with a clean cloth. Replacethe pan in the
switching off the circuit breaker. Make sure warming drawer or lower oven drawer.
the drawer heating element is cool.
NOTE:Allow warming drawer or lower oven
drawer to cool before removing pan.
NOTE:Wipe spills promptly after each use.
IAWARNING
IA CAUTION
Socket
Receptacle /
Glass cover
(on some models)
Receptacle Socket
i
_Bulb
i i
i i i
i i i
Glass cover
/40 (on some models)
I HOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect
the electrical power to the range at the main fuse or circuit breaker panel.
Failure to do so may result in electric shock or burn.
I BURN HAZARD: The glass cover and bulb should be removed when cool.
Touching hot glass with bare hands or a damp cloth can cause burns.
Oven Light Replacement Ion some models)
To remove:
[] Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear
the grooves of the socket. Wearing latex
gloves may offer
a better grip.
r_ using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
Use a new 120/130-volt halogen bulb, not
to exceed 50 watts. Replacethe bulb with
the same type of bulb that was removed.
Your model will have one of the two types
shown on the left. To determine the
correct replacement bulb, check the bulb
terminals. Bulbswith 2 straight pin
terminals are G6.35 bulbs. Bulbs with 2
looped terminals are G9 bulbs. (Do not
interchange.) Be sure the replacement
bulb is rated 120 volts or 130 volts (NOT12
volts).
[]
Using gloves or a dry cloth, remove the
bulb from its packaging. Do not touch the
bulb with bare fingers. Oil from skin will
damage the bulb and shorten its life.
Receptacle
@
[]
Pushthe bulb straight into the receptacle
all the way.
Placethe tabs of the glass cover into the
grooves of the socket. Turn the glass cover
clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
[] Reconnect electrical power to the oven.