Table of Contents
Advertisement
IMPORTANT
The mains lead on this equipment may be supplied with a moulded plug incorporating a fuse,
the value of which is indicated on the pin face of the plug. Should the fuse need to be
replaced, an ASTA or BSI approved BS 1362 fuse must be used of the same rating. If the fuse
cover is detachable never use the plug with the cover omitted. If a replacement fuse cover is
required, ensure it is of the same colour as that visible on the pin face of the plug. Fuse
covers are available from your dealer.
DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the
power points in your home or the cable is too short to reach a power point, then obtain an
appropriate safety approved extension lead or consult your dealer.
Should it be necessary to change the mains plug, this must be carried out by a competent
person, preferably a qualified electrician.
If there is no alternative to cutting off the mains plug, ensure that you dispose of it immediately,
having first removed the fuse, to avoid a possible shock hazard by inadvertent connection to
the mains supply.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
Blue
: NEUTRAL
Brown : LIVE
As these colours may not correspond to the coloured markings identifying the terminals in
your plug, proceed as follows:
The wire coloured BLUE must be connected to the terminal marked with the letter N or
coloured BLUE or BLACK. The wire coloured BROWN must be connected to the terminal
marked with the letter L or coloured BROWN or RED.
On no account connect either of these wires to the terminal marked E or by the earth symbol
E or coloured green or green and yellow.
Alternatively, this equipment may be supplied with a rewireable plug already fitted, which
may be removed if not suitable and an alternative fitted in accordance with the preceding
instructions.
3
YOUR GUARANTEE OF EXCELLENCE
Thank you for purchasing this Hitachi product
In the unlikely event that this product should develop a fault, we undertake to replace or repair any
part of the product which fails due to a manufacturing defect within 12 months of the date of
purchase provided that:
i) The product has been installed and used only in accordance with the instructions supplied with
the product.
ii) The product has not been repaired, maintained, or modified by any person other than a Hitachi
authorised engineer.
iii) The product serial number has not been removed or altered.
This guarantee does not apply to product acquired second hand or for commercial or communal
use.
This guarantee does not cover the replacement of exhausted batteries, the adjustment of user
controls, or head cleaning and general consumer maintenance tasks.
Any parts replaced under this guarantee shall become the property of Hitachi Europe Ltd. Any
claims made under guarantee must be directed to the dealer from whom the equipment was
originally purchased.
Please note that evidence of the date of purchase will be required before any service under this
guarantee is carried out.
THIS GUARANTEE DOES NOT AFFECT YOUR STATUTORY RIGHTS.
IN ALL CASES OF DIFFICULTY PLEASE CONSULT YOUR HITACHI DEALER
4
Advertisement
Table of Contents
