Storm Window Requirements - GE AJCM Series Owner's Manual And Installation Instructions

Installation Instructions
[] STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt towards the outside and will keep
it from draining properly. To adjust for this, attach
a piece of wood to the stool.
/ Wood
J
1/2" higher #
thanframe t
Storm
window
frame
WOOD PIECES
WIDTH: 2"
LENGTH: Long enough to fit inside the window frame.
THICKNESS: To determine the thickness, place a piece
of wood on the stool to make it 1/2" higher than the top
of the storm window frame.
Attach securely with nails or screws provided by
the installer.
131 REMOVE AIR CONDITIONER FROM CASE
[] Remove the front grille. See the Care and Cleaning
section.
r_ Find the locking plate located on the front
left side.
rcl
L°kn !i j ate
em°ve]l
screw
Remove the screw and the locking plate to unlock
the air conditioner.
r_ Remove and discard the shipping screw
on the back of the air conditioner to allow
removal of the air conditioner from the case.
Remove
screw
r_ Pull the bottom corners of the air conditioner
and slide it out of the case.
r_ Removeall shipping pads (if present)inside the air
conditioner next to the compressor.
re]
Remove shipping pads
(if present)
Remove the rear grille that is taped to the back
of the case. Remove the packet of screws taped
to the back of the grille. While holding the grille at a
45 ° angle, insert it into the clips at the top of the case
and push the bottom in. Keep slight upward pressure
on the grille until it fits flush with the bottom of the
case.
If attaching the grille If attaching the grille
from the outside of the from the inside of the case,
case, use the 2 long screws, use the 2 short screws.
Clips
Insertthe 2 longscrews
onthe outside
I /llllllllllllllllllllllllllllllllllllllllllllj I
HIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII /i
/1111111111111111111111 II
!__!llllllllllllllllllllllllllllllllllllllllllll
Insert the 2 short screws
onthe inside
17