GE PHP900 Owner's Manual page 11

Electronic induction
Hide thumbs Also See for PHP900:
Table of Contents

Advertisement

Available languages

Available languages

ge.com
"H" indicates that the Boost power
level has been selected for rapid
cooking and boiling.
Boost Setting
Boost isthe highest power level, designed
for large quantitg rapid cooking and
boiling. Boost will operate for a maximum
of 10 minutes. After 10 minutes, it will
automaticallg revert to power level9.
Boost mag be repeated after the initial
10 minute cgcle.
CAUTION:Do not leave a pot unattended
while in the Boost Mode.
Tostart the Boost power setting:
[]
Placea pan matching the size of the
induction element over the selected
indicator ring.
[]
Touch the ON/OFF pad. "5" will flash
in the displag.
[]
Touch and hold the (+)pad until the
displag reads "HI'
NOTE:If the pan is removed, the displag
will flash "F" alternating to "H', After 30
seconds, the elements will turn off
automaticallg.
Sounds you may hear:
You mag hear a slight "buzz"sound when
cooking with the Boost or high mode. This
is normal. The sound depends on the tgpe
of pot being used. Some pots will "buzz"
louder depending on the material. A "buzz"
sound mag be heard if the pan contents
are cold. As the pan heats, the sound will
decrease. If the power level is reduced, the
sound level will go down.
Power Sharing
Four burner cooktops are divided into two separate
i
ii
_ i
ii
4 burner cooktops with right and left side (2)induction generators.
i
iiiiii ii i)i _i _i_i _i _i_i _i _i_ i_ i_ i_ i_ i_ i_ i_i iiii:
heating zones.The right and left side cooking zones
are powered bg separate and independent induction
generators. One generator controls 2 elements, or two
cooking zones within a heating section share the power
of one generatoE
Five burner cooktops are divided into 3 zones.The
right and left side have separate cooking zones and the
large center element is another separate cooking zone.
Power Sharing is activated when both elements in the
same cooking zone are activated and one element is
set for Boost (H). T he element that is not set for Boost
will change to a lower power level.This is called
Power Sharing.When Boost operation is complete
(10 minutes),the other element mag be reset to ang
power level. Both elements can operate simultaneouslg
at normal power levelsettings of "L"to 9.
IMPORTANT NOTE FOR FOUR BURNER MODELS:
The elements on the right side shore one generoto_
Both elements con operate at any non-Boost (level L
to 9) power level at the some time. If the large front
element is set for "H" or Boost, the smaller element
at the right rear will be deactivated or turned off
automatically. The smaller right rear element con be
activated and set for any power level after the Boost
operation of the larger element is completed (10
minutes).
5 burner cooktops with right, left and center (3) induction generators.
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Php960

Table of Contents