Installation Instructions - GE 22 Owners And Installation Manual

Installation
Instructions
Refrigerator
Models 22 and 25
ff you have questions, call 1-800-GECARES
or visit our Website at:
www.GEAppliances.com
I
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT - these
instructions for local inspector's use.
• IMPORTANT
- Obse, ve ,ll
governing codes and ordinances.
• Note to Installer
_
Be sure
to
leave these
instructions with the ConsumeL
• Note to Consumer _ Keep
these instructions
for filture reference.
• Skill level - Installation of this appliance requires
basic mechanical skills.
• Completion time - Refiigerator Installation
15 minutes
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under tile Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
If tile refligerator has an icemakm; it will have to be
connected to a cold water line. AGE water supply kit
(containing robing, shutoff vane, fittings and
instructions) is available at extra cost flom your deale_;
by visiting our Website at www.GEAppliances.com or
flom Parts and Accessories, 800-626-2002.
REFRIGERATOR LOCATION
• Do not install tile refligerator where tile temperature
will go below 60°F (16°(;) because it will not run
often enough to maintain proper temperatures.
• Do not install tile refrigerator where tile temperature
will go above 100°F (37°(;) because it will not
perform properly.
• Install it on a floor strong enough to support it filly
loaded.
CLEARANCES
Allow tile following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 1/8" (4 mm)
• Top 1" (25 mm)
• Back 1" (25 mm)
If tile refligerator is against a wall on either side, allow
a 1/8" (3 ram) door clearance.
ROLLERS
The rollers have 3 purposes:
•
Rollers adjust so tile doo_s close on their own when
opened about 45 °.
•
Rollers adj ust so tile reflJgeramr is fimdy positioned
on the floor and does not wobble.
•
Rollers allow you m move die refligerator away flom
the wall for cleaning.
To adjust the rollers:
Remove tlle base grille by
positioning hands as shown.
O Rotate tile bottom of tile
grille outward until tile clips
snap out.
Pull tlle grille away flom tile
refl_igeratoL
%N _-x
Using a screwdriver; mrn tile _
two flont roller adjusting
screws clockwise to raise tile
refligeratot;
counterclockwise to lower it.
Replace tile grille so tile
notch in tile grille will fit
O
O
around die bottom door
hinge.
Tilt tile top of tile grille
toward tile refligerator and
insert the long metal clips
into tile top of tile oval
openings at tile bottom of
tile refligeramL
Rotate tile bottom of tile grille toward
tile refligerator until it snaps into place.
J
J
13