GE 22 Owners And Installation Manual page 20

Installation instructions
REVERSING THE DOOR SWING ICONT.I
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
Remove the base grille by pulling it straight out.
Using a Torx Driver, move the bottom hinge bracket
from the right side to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the dooL
%
I-_ TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket by removing the
three Torx screws
NOTE: Keep these screws with the hinge bracket.
They are long screws and will be used when
installing the hinge on the other side.
You will need to remove the colo>matched cap
fiom the screw head before you can remove the
screw. Use the edge of a thin fiat blade to gently P_T
the caps off"the screw heads. (A putty knife works
well for tiffs.) Gover the blade with rope to prevent
scratching the paint.
Remove the mullion cover flom the left side using
the thin fiat blade. Assemble it to the right side.
Remove the Torx screw flom the center left side
of the cabinet. Screw it into the holes on the
right side.
Place the center hinge bracket over the holes at the
center left side of the cabinet. Insert and tighten the
three long screws.
Replace the cap by snapping it over the screw with
your fingeL
I-_ TRANSFER DOOR STOPS
On each door, move the metal door stop flom the
right to the left.
Move any screws flom the left to the right.
20