Table of Contents
Advertisement
t.JREt'ARAIION
POR
USE
VttF/UttF
COMBINED
A N 1I'_NNA
The VHF/UHF Rod Antenna (not supplied) is detach-
able. Push the stem of the antenna into the hole which
is located on the upper back cabinet of the unit.
Connect the VHF/UHF
Rod Antenna or VHF/UHF
Combination
Antenna
to the ANT. terminal of the
TV/VCR as shown in the diagram below.
For the best reception, extend the VHF/UHF Rod An-
tenna fully and adjust its position. (Avoid handling the
top section when making adjustments.)
VHF/UHF Antenna
Rod Antenna
(Not Supplied)
NOTE:
........
Before plugging the Rod antenna into antenna terminal,
check that the pin is not bent. If it is bent, straighten the
pin as illustrated, then plug the pin into antenna terminal.
Bent pin
(Needs to be straightened)
(Straight pin)
VItbTUttF
SEPA RA I'E A N 1'ENNA S
In some areas it will be necessary to use an outdoor an-
tenna.
VHF Antenna
JHF Antenna
Flat twin-lead cable
CABLE WITHOUT
CONVERTER/
DESCRAMBLER
BOX
Use this connection if your cable system connects di-
rectly to your TV/VCR without a converter box.
With this connection you, 1) can use your TVNCR Re-
mote Control to select channels, 2) program one or more
unscrambled channels for Automatic Timer Recording.
,
i
, _
L
, r
_L' _'q
"
From Cable System
, :
_.__,
...,.: . ...
75-ohm
Coaxial Cable
(not supplied)
ANT.(_
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building as close to the point of cable entry as practical.
EN
- 10 -
6F18
Advertisement
Table of Contents
