Table of Contents
Advertisement
This function enables you to set a recording length sim-
ply by pressing the REC/OTR button on the TV/VCR.
Make sure ...
• Power must be turned on.
• Insert a cassette tape with its erase prevention tab in
place. (If necessary, rewind or fast forward the tape
to the point at which you want to begin recording.)
NOTE:This function cannot be done by the remote con-
trol.
i|
i
•
i
....
1
Select the channel to be recorded
Press number buttons on the remote control or the
CHANNEL • or • button.
2
Begin OTR
Press REC/OTR button on the I°_(2:_°)
]
TV/VCR
as many
times
as
needed. The recording
length
will be determined by the num-
_P
_
•
ber of times you press RECtOTR
button.
Each additional push will increase the recording time by
30 minutes. It is set up to 8 hours.
Push(es)
1 push
2 pushes
3 pushes
,L
17 pushes
Display
0:30
1:00
8:00
Recording length
(normal recording)
30 minutes
60 minutes
480 minutes
HINTS:
• Recording starts immediately when the REC/OTR
button is pressed.
• When REC/OTR
button is pressed 18 times, the
TV/VCR will switch to the Normal Recording mode.
• To stop the OTR operation, press STOP button onthe
TV/VCR or on the remote control.
• To show the remaining time, press SELECT button
repeatedly until "OTR" appears on the TV screen.
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode maximum record-
ing time, assuming the tape is started at the begin-
ning, is 8 hours using T- 160 (or 6 hours using T- 120).
• If the tape runs out before the end time, the TV/VCR
will switch to the Stop mode immediately, eject the
tape and the TV/VCR power will be turned off.
Connect your TV/VCR and a Source (Playing) VCR us-
ing the following diagram.
[Connection
1 }
::
[Editing (Recording) TVNCR]
A
IDE
VCR <HIFi>] _
Audio/Videoadaptercord
(notsupplied)
[Connection
21
[Editing(Recording) TVNCR]
J
III,u v l
III III
(Playing) _\ _
VCR <HIFI>]_
'
"
Audio/Video adaptercord
(notsupplied)
1) Insert a pre-recorded video cassette into the Source
(Playing) VCR.
2) Insert a blank video cassette, or one you want to record
over, into the TV/VCR's cassette compartment.
3) Press SPEED button to select the desired recording
speed (SP, LP or SLP).
4) Press CHANNEL • or • button repeatedly so that
"AUX" appears on the screen.
5) Begin playback of the tape in the Source (Playing)
VCR.
6) Press REC button on the TV/VCR.
NOTES:
• For best results during dubbing, use the TV/VCR's
front panel controls whenever possible. The remote
control might affect the Source (Playing) VCR's
playback operation.
• When you connect the monaural TV/VCR(another
source) to this TV/VCR, connect the Audio output
jack of the monaural VCR(another
source) to the
AUDIO IN L jack of this VCR. The audio signal will
be recorded in both L and R channel equally.
i
- 26 -
EN
6FI8
Advertisement
Table of Contents
