Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLY
UNPACK CARTON & INSTALL HANDLE
(See Fig. 2)
_1
CAUTION:
Be careful
of exposed
staples when handling or disposing of
cartoning material.
IMPORTANT:
WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOT TO STRETCHOR KINK CABLE(S).
•
Cut cable ties securing handles.
•
The handle may be assembled
in high or low posi-
tion. Slowly lift handle assembly up, route cable(s)
as shown and align handle holes with desired handle
panel hole and slot.
•
Loosely assemble hardware as shown.
Be sure the
shorter (1" long) hex bolt is assembled in lower hole
of handle.
Repeat for opposite side.
Tighten all
hardware securely.
NOTE: Cables must not touch the muffler.
•
Cut cable ties securing tiller to skid and remove tiller
from skid.
•
Remove screws securing depth stake to skid and
discard the screws.
HANDLE PANE_=_
TILLER
HANDLE
CABLE
HEX BOLT
5/16-18 x
i-i14"
HANDLE
HANDLE
PANEL
BOLTS
INSTALL
DEPTH STAKE ASSEMBLY
(See Fig. 3)
•
Loosen nut "A".
•
Insert stake support between engine bracket halves
with stake spring down.
•
Boltstakesupporttoenginebracketswith5/16x1-1/4"
bolts, lock washers and nuts. Tighten securely. Tighten
nut "A".
•
Depth stake must move freely. If it does not, loosen
support bolt.
ENGINE BRACKET
HALVES
NUT'W'
DEPTH STAKE
SUPPORT
SUPPORT
BOLT
DEPTH
STAKE
STAKE SPRING
HEX BOLTS,
LOCK WASHERS,
AND HEX NUTS
Fig. 3
HANDLE
HEIGHT
•
Handle height may be adjusted to better suit operator.
(See "HANDLE HEIGHT" in the Service and Adjust-
ments section of this manual).
TILLING
WIDTH
•
Tilling width may be adjusted to better handle your
tilling conditions
(See "TINE ARRANGEMENT"
in the
Service and Adjustments
section of this manual).
TINE OPERATION
•
Check tine operation
before first use.
(See "TINE
OPERATION CHECK" in the Service and Adjustments
section of this manual).
Fig. 2
5
Advertisement
Table of Contents
