Frigidaire FNDP15B1 Installation Instructions Manual page 5

5.8 CUft DRYER (STYLE 2)INSTRUCTIONS (GREEN KIT)
Cs) Attaching dryer (style 2) mounting
hardware
1,
dryers to the pedestal:
Dw_Yh r2canbd: :tt s(Sty'e'd)e [/_1 II_[
and 4 inch knockout
for IN1 INI
side vent_g.
I lil
2. Attach each front clip to outer-most set of holes with 2 screws.
Use the following instructions for mounting any of these types of
NO spacers under front brackets.
[ ;;
3. Insert "B" tab of each rear bracket into the front slots on rear of
pedestal. Orient bracket outward for "style 2" dryer mounting.
aBb---_ front
\.\ slot
_:_b outward
4. Install 2 screws through each rear bracket into aligning pedestal
holes.
D3) Mounting dryer (style 2)
- EXCESSIVE WEIGHT HAZARD - To avoid
back or other injury, have more than one person move or lift
the dryer.
Using two or more persons, slightly tip the dryer back and lift it
onto the pedestal. Still tipped, slide the dryer back against the
rear brackets so tabs on rear brackets engage the slots on the
back of the dryer. Gently set down the front so the appliance is
between the front and rear brackets.
ENGAGE REAR TABS
2,
3.
I
/ TiP DOWN
Adjust the appliance side-to-side to align its mounting holes with
the pedestal's bracket holes.
Install a screw through each front bracket into the base of the
dryer.
Es) Installing or re-installing dryer (style 2)
1. Slide appliance/pedestal into place.
2. Check for levelness and rock all four (4)legs again. Repeat until
level and solid.
3. Refer to Dryer Installation Instructions for complete details on
installing electrical, gas, or exhaust venting.
O
m
m
Z
m
®
IT1
m
Z
m
-q
o
m
m
Z
m
-q
o
m
m
Z
m
-q
o
m
m
Z
m
-q
o