Advertisement
Available languages
Available languages
@
C4) Attaching
washer mounting
hardware
1. Use the following instructions for mounting this type of washer
to the pedestal:
m
"I"
@
m
@
m
m
"I"
@
m
m
"I"
@
m
n
@
m
n
®
Remove 2 screws
from service access
below front
panel.
J
2,
3.
Remove lower service access panel.
Remove 2 lower screws from backsheet of washer. Save screws to
reinstall later.
i, _
i
i
Remove 2 screws from
washer backsheet.
\_
"[ .....
J
4. Attach each front clip to outer-most set of holes with 2 screws.
®
i iil
5. Insert "A" tab of each rear bracket into the middle slots on rear
of pedestal. Orient bracket outward for washer mounting.
"A"'_J
_'°_°' middle
tab
_slot._
outward
,/
/
6. Install 2 screws through each rear bracket into aligning pedestal
holes.
D4) Mounting
washer
- EXCESSIVE WEIGHT HAZARD
- To avoid
back or other injury, have more than one person move or lift
the washer.
Using two or more persons, slightly tip the washer back and lift it
onto the pedestal. Still tipped, slide the washer back against the
rear brackets and gently set down the front so the appliance is
between the front and rear brackets.
2,
3.
Adjust the appliance side-to-side to align its mounting holes with
the pedestal's bracket holes.
Reinstall backsheet screws removed earlier through each rear
bracket into the base of the washer.
i
4. Reinstall the lower service access panel.
5. Reinstall the 2 screws removed earlier through the outer hole of
each front bracket into the base of the washer.
E4) Installing
or re-installing
washer
1. Slide appliance/pedestal into place.
2. Check for levelness and rock all four (4) legs again. Repeat until
level and solid.
3. Refer to Washer Installation
Instructions
for complete details
on installing water, drain, or electrical.
Advertisement
