Related Manuals for Philips DS8300
Summary of Contents for Philips DS8300
- Page 1 Always there to help you Register your product and get support at www.philips.com/welcome DS8300/10 Question? Contact Philips User manual...
-
Page 3: Table Of Contents
Contents 1 Important Safety Compliance Care of the environment Notice 2 Your Docking Entertainment System Introduction What's in the box Overview of the main unit 3 Get started Prepare the remote control Connect power Turn on 4 Play Play from iPod/iPhone/iPad Play from Bluetooth device Play from an external device Adjust volume level... -
Page 4: Important
Portable Document Format • Where the mains plug or an applicance (PDF) version of the user manual at www. coupler is used as the disconnect device, philips.com/support. the disconnect device shall remain readily operable. Note Risk of swallowing batteries! •... -
Page 5: Notice
Notice The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Philips is under license. -
Page 6: Your Docking Entertainment System
2 Your Docking Overview of the main unit Entertainment System Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can enjoy audio from the iPod/iPhone/iPad and other audio devices. • Select Bluetooth mode • Pair with Bluetooth device. What's in the box... -
Page 7: Get Started
Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. -
Page 8: Connect Power
Connect one end of the AC power cord to the AC adaptor. Connect the other end of the AC power cord to the wall outlet. Note • Before pressing any function button on the remote control, first select the correct source with the remote control instead of the main unit. •... -
Page 9: Play
» LED under button on the main unit flashes rapidly. Turn on Bluetooth function on your device. Search for Bluetooth devices that can pair with your device. When “PHILIPS DS8300” displays, select it to start connection. » Double beep tone confirmation is Remove the iPod/iPhone/iPad heard and the LED turns on stably if connection is successful. -
Page 10: Play From An External Device
Turn off the connected device or move it Adjust volume level beyond the communication range. » LED flashes. During play, press VOL +/- to increase/ To erase Bluetooth paring information • decrease the volume level. Press and hold for 5 seconds. » The unit beeps once after paring information is cleared successfully. -
Page 11: Product Information
5 Product Standard Bluetooth 2.1 + EDR information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2X15 W RMS Signal to Noise Ratio 65 dBA Audio-in Link 0.6 V RMS 10 kohm General information AC power (power adaptor) -
Page 12: Troubleshooting
check the following points before The paired device connects and disconnects requesting service. If the problem remains constantly. unsolved, go to the Philips web site (www. philips.com/welcome). When you contact • The Bluetooth reception is poor. Move Philips, ensure that the apparatus is nearby the device closer to the system or remove... - Page 14 Specifications are subject to change without notice © 2013 Koninklijke Philips Electronics N.V. All rights reserved. DS8300_10_UM_V2.0...