To Change The Pasta Plates; To Loosen The Pasta Ring - KitchenAid KPEXTA Instructions And Recipes Manual

4,
To Use Pasta Press Accessory
Use the swing-arm wire dough
cutter to cut pasta at desired length
as it exits the press. See page 5 for
recommended lengths.
To Loosen the Pasta Ring:
1. If pasta ring is too tight to remove
by hand, slip the wrench over the
grooves.
2. Turn pasta ring in direction indicated
by the arrow to OPEN.
5. Separate pasta as described on page 5.
To Change the Pasta Plates:
1. Turn Stand Mixer speed control to OFR
2. Unplug Stand Mixer or disconnect
power.
3. Remove the Pasta Pressaccessory from
the Stand Mixer.
4. Remove the cutter, pasta ring, auger
and clean the dough out of the press
housing.
5. Then reassemble the accessory as
stated on page 4.
NOTE: Do not use wrench to attach ring
to press housing. Damage to the accessory
may result.
NOTE: When using the machine, do
not wear ties, scarves or long necklaces;
gather long hair with a clasp.