Remote Control; Reference Page 1. Remote Control Transmitter; On/Stand-By Button - Sharp SD-AT1000 User Manual

Remote control

! Battery installation
1 Open the battery cover.
2 Insert the batteries according to the direction indicated in the bat-
tery compartment.
When inserting or removing the batteries, push them towards the
nals.
3 Close the cover.
Precautions for battery use:
" Replace all old batteries with new ones at the same time.
" Do not mix old and new batteries.
" Remove the batteries if the unit is not to be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
" Do not use rechargeable batteries (nickel-cadmium battery, etc.).
" Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
" Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
" Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
" Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
" Keep the remote control away from moisture, heat, shock, and vibrations.
! Test of the remote control
Check the remote control after checking all the connections (see pages 9 - 12).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
battery termi-
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your
system.
03/3/14 SD-AT1000H_SEEG_E.fm
SD-AT1000H
ENGLISH
Remote sensor
0.2 m - 6 m
(8" - 20')
E-14
TINSZ0943AWZZ
1
2
3
4
5
6
7
8