Panasonic DIGA DMR-E85H Operating Instructions Manual page 50

Operation Page
The unit is on but cannot be
operated.
Cannot eject disc.
• Recording drive or playback drive has not been selected properly. 16, 24
eSome operations may be prohibited by the disc.
eThe unit is hot ("U14" appears on the display). Wait for "U14" to disappear.
eOne of the unit's safety devices may have been activated.
Reset the unit as follows:
Press [POWER _/I] on the main unit to switch the unit to standby.
If the unit doesn't switch to standby, press and hold [POWER _/I] on the main unit for about
10 seconds. The unit is forcibly switched to standby.
Alternatively, disconnect the AC power supply cord, wait one minute, then reconnect it.
eThe unit may have a problem. While the unit is off, press and hold [m] and [CH ^] on the
main unit at the same time for about 5 seconds. Remove the disc and consult the dealer.
Recording/Timer recording/Transferring (dubbing)
Timer recording does not work
properly.
VCR Plus+ system does not
work properly.
The timer program remains
even after recording finishes.
Cannot transfer (dub) to a DVD-
R disc using the high speed
mode.
An unusually loud sound
coming from the rotating
DVD-R.
• The timer program is incorrect or different timer program times overlap. Correct the program.
eTimer recording program may be deleted if there is an interruption to the power.
eVCR Plus+ system works only after this unit downloads the television program list.
• The timer program remains unless set to "Once".
• When recording to the HDD, set "DVD-R High-Speed Recording" to "On" in the SETUP
menu.
• When recording or high speed transferring (dubbing) to a DVD-R, the sound of the disc
rotating may be louder than normal; however, this is not a problem.
22
19, 20
41
RQT7305
m