Cloning Connections/Learning Setup - LG 20LH1DC1 - 20.1IN LCD HOSPITAL GRADE PRO-IDIUM ATSC/NTSC/QAM Operation Manual

COMMERCIAL MODE
CLONING CONNECTIONS/LEARNING SETUP
Connections for the LT2002 Clone Programmer to Learn the 20LH1 DC1 Master TV Setup
N
0
I'rl
N
J
r"
0
I'rl
I
or CATV
I
I
I
I
I
I
I
I
\ /
I
I
MPl
QuickSet il Programmel
L T2002
Warning: Do not use LT2002
if a LodgeNet PPV card is
installed in TV or clone
programmer device will be '
damaged. Master 20LH1 DCl Clone Programmer
*Note1 : It is assumed that the 20LH1DC1 is connected to a signal source, the source selected is Antenna (RF) In, the signal is from an
Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone Programmer main menu
(THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, the clone programmer LED is blinking the required heart
beat pattern, see above and next page.
*Note2: Once the clone is connected, do not touch the unit or otherwise disturb it or the MPI connections. Any disturbance while the clone
is operating may disrupt the master setup transfer or copying etc.
Before you begin cloning...
• The Master 20LH1DC1 should be connected to a
good, stable signal from an over-the-air antenna or
cable service Analog channel and connected to power.
(See above.)
• Teaching and Learning is only possible between
identical model devices. (However, the LT2002 Clone
programmer can store up to 3 different 'master'
setups.)
WARNING: Copying a blank or incorrect memory into a
TV, STB or other device will cause the TV, STB or
other device to operate erratically or become
inoperable.
• Use an Installer's remote to operate Learning and
Teaching menus.
• Make sure that the batteries in the Clone programmer
are fresh.
• If batteries are removed, the Clone Clock time will be
lost.
• Decide if you want to set the time from the Clone
programmer or copy the time to the Clone
programmer; from a compatible TV which has the clock
set to the current time.
• Setting the time and transferring it to the Clone or
other device is a separate procedure.
• Follow the connection diagram above to connect the
Clone to a Master 20LH1 DC1-UB TV display panel.
After learning is complete, to another identical
20LH1 DC1-UB TV display panel to "teach" it the
master setup.
• After the 20LH1 DC1 -UBs setup has been copied to
another identical 20LH1 DC1, that identical unit with
the copied setup, needs to be disconnected from
power for about 15 seconds to activate the
newly-copied setup.
• See the Clone Troubleshooting section to resolve
problems.
Turn to the next page to continue Cloning Setup.
52