Snmp Agent - Dell Broadcom NetXtreme Family of Adapters User Manual

Use names such as BASP1 for TEAM 1, BASP2 for TEAM 2, BASP3 for TEAM 3 and BASP4 for TEAM 4.
When you modify a team, you may need to reboot after reinitialization for the changes to take effect.
Repeat steps 22 through 27 to configure an additional physical driver and to configure additional frame types. The
configuration can be viewed in the View Configuration - All INETCFG Commands console.

SNMP Agent

This SNMP agent is designed to support the configuration information pertaining to the Broadcom BASP driver for NetWare.
Installation
When the BASP.LDI driver is installed using nwconfig or nwinstall, the driver automatically copies the BASP.LAN,
bmapi.nlm, and bsnmp.nlm files to the system.
After you configure and run the BASP and bind the BASP to network adapters, load the Broadcom SNMP Instrumentation
Agent (BSNMP) as follows:
From the NetWare Server console command line interface, type:
load bmapi.nlm
load bsnmp.nlm
SNMP Objects
BASP SNMP objects are provided in the BASP-Config.MIB file, which is on your driver source media. The snmpget and
snmpgetnext commands can be used to receive the BASP SNMP objects such as:
snmpget localhost public BASP-Config-MIB::btTeamNumber
snmpgetnext localhost public BASP-Config-MIB::btTeamNumber
NOTE: Only BASP configuration information is available through SNMP in NetWare. Statistical events are only available for
the base adapters
Files
BASP.LAN
bmapi.nlm
bsnmp.nlm
BASP-CONFIG.MIB
Please read all Restrictions and
Back to Contents Page
Disclaimers.