Sony KP-48S65 Operating Instructions Manual page 6

Although you can use either an indoor or outdoor
antenna with your projection TV, we recommend that
you connect an outdoor antenna or a cable TV system
to get better picture quality.
Connecting an antenna
Connect your antenna cable to the VHF/UHF antenna
terminal. If you cannot connect your antenna cable
directly to the terminal, follow one of the instructions
below depending on your cable type.
A
• VHF only
or
• VHF/UHF •
or
• Cable
75-ohm coaxial cable
(Rear of projection TV)
VHF/UHF
B
• VHF only
or
• UHF only
or
• VHFIUHF
(Rear of projection TV)
300-ohm twin lead cable VHF/UHF
Antenna Iconnect_
C
• VHF
and
• UHF
75-ohm coaxial cable
_EAC46 u/vlRear of projection TV)
mixer
"Jl (not supplied)
[
300-ohm twin lead cable
Notes
* Most VHF/UHF combination antennas have a signal splitter.
Remove the splitterbefore attaching the appropriateconnector.
• If you use the U/V mixer, snow and noise may appear in the
"picturewhen viewing cable TVchannels over 37.
Connecting an antenna/cable TV
system without a VCR
To cable or antenna
Cable
(Rear of proTe"_ion TV)
VHF/UHF
To cable box
If your cable company requires you to connect a cable
box, make the connection as follows:
(Rear of projection TV)
VHF/UHF
ab'e . ,
Cable box
To cable box and cable
Cable box
I (Rear of projection TV)
75-ohm coaxial
cable (not supplied)
VHF/UHF
CAW cable
Pay cable TV systems use scrambled or encoded signals
requiring a cable box* in addition to the normal cable
connection.
* The cable box will be supplied by the cable company.
Note
• You cannot watch the signal through an AUX connector as a
window picture.
To cable and antenna
CATV cable
(Rear of projection TV)
AUX
TO
CONVERTER
Antenna cable
VHF/UHF
Note
• Do not connect anyfldng to the TO CONVERTER connector in
this case.
6"EN I
Getting
Started