For additional instructions from this point forward, refer to your Controller software
documentation.
Note: Restart the host computer to recognize new and exchanged devices.
6.2
Exchanging Drives
The procedure to exchange drives is similar to adding drives described in the previous section.
However, use the drive exchange command to eliminate possible bay and ID assignment
errors.
Note: It is best to duplicate the existing drive's SCSI ID and termination switch settings to the new
drive.
1. Enter the System Administrator.
2. Enter the Door submode to open the rear access panel.
The following message appears on the LCD display:
3. Return to the System Administrator mode.
M a g a z i n e – b a y o r
R e a r ( d r i v e ) – b a y ?
Press the Escape button
( C o n f i g )
S e t u p b r o w s e r
Press the Escape button
( I n q u i r y )
I D = 5
*
R e v i s i o n
Press the Escape button
F r o n t - d o o r
:Close
R e a r - d o o r
:Open
Close the rear access panel
I n i t i a l i z i n g
Initialization complete
R o b o t i c s
D r i v e 1
no disc
F r o n t - d o o r
:Close
R e a r - d o o r
:Open
- 43 -
DRM-7000
* * *
.
ready
Operating Instructions