Pioneer RM-V2400NA Technical Manual page 56

(5) Paste cushion A (BMR1106) to the top board of the
multi-projection unit and cushion B (BMR1107) to the
1 2 3 4
1 2 3 4
two sides at the position shown in the figure after
1 2 3 4
peeling off the seal.
(6) Insert the multi-projection unit from the rear of the
unit in this state.
Cushion A
(BMR1106)
* Paste after adjusting the
center of the top board to
that of cushion A.
Cushion B
(BMR1107)
* Paste without cover-
ing the fan.
Unit
INSTALLATION AND ASSEMBLY
(7) Attach the attachments R and L to the unit through the
top board of the unit using the screws (M6
then attach attachments R and L to the unit from the
back using screws (M6
Screws
(M6 20)
*Drop the screw-lock fluid to screws so as not to loosen.
(4 points)
(8) Check the Focus and readjust if necessary.
(9) Attach the cover (BNE1012) to the top board of the unit
using the four screws (M5
20) and
20). (2 screws 2 locations).
Screws
(M6 20)
15).
Screw (M5 15)
Cover
(BNE1012)
55