Fujitsu MVGA-NVG11A User Manual page 26

Q: When I install the 5.xx series of drives Windows 9x locks up at the
bootup screen. How can I fix it?
A: Make sure your MVGA-NVG11A/P/AL/AT/PT is not sharing an IRQ with any
other devices. If you find that it is, try either moving the device into another PCI
slot, or reassigning the PCI IRQs in the BIOS. In particular, the first PCI slot is
frequently forced to share an IRQ with the AGP slot.
Q: If I set the MVGA-NVG11A/P/AL/AT/PT as the primary card in the
BIOS, my secondary PCI video card is not detected. How can I fix it?
A: Check in your C:\CONFIG.SYS file to see if you are loading EMM386.EXE. If
you are, remove the line.
Q: Games stutter with my MVGA-NVG11A/P/AL/AT/PT. How can I fix it?
A: 1. Go into the System Control Panel, then click on Device Manager, and then
find your CD/DVD-ROM drive(s) and hard drive(s). Go into each one, click
on Settings and check DMA. This enables UltraDMA.
2. Make sure that Video BIOS shadowing is disabled in your BIOS.
3. Make sure that your MVGA-NVG11A/P/AL/AT/PT card is not sharing any
IRQs with another card - the only device that can have the same IRQ is the
'IRQ Holder for PCI Steer ing'. If you find that the GeForce2 MX is sharing
an IRQ, try moving the card that it is sharing the IRQ with to another slot.
Q: I get flickering textures in Quake 3 Arena and Windows 9x. How can I
fix it?
A: Type the following at the console:
˙ /r_ext_compiled_vertex_array 0
˙ /vid_restart
Q: I can't get my system to work with AGP4X. It only can work in
AGP2X.
A: 1. You must enable AGP in 4X mode in BIOS of motherboard.
2. You need to confirm motherboard have support AGP 4X mode.
3. You need to enable AGP in 4X mode during install VIA 4-in-1 procedure.
Q: I have 2 jumpers on my VGA card, what for they are? How can I set
this jumper?
A: 1. They are for TV-OUT function in DOS mode.
2. JP1/JP2 Short 1-2 for NTSC, JP1/JP2 Short 2-3 for PAL.
22