Haier HWD–C1200TXVE-U User Manual page 8

08
InStALLAtIon
iNLEt hOSE
1 . Connect the nut on the inlet hose to the connector on
the water valve .
2 . Apply inlet hose to a water tab with cold, fresh water .
Note: Use the hose-set supplied with the
appliance. Old hose-sets should not be reused.
DRAiN hOSE
1 . Use the drain hose bracket to keep the end of the
drain hose retained and prevent the outflow of
water . Don't extend the length of the drain hose;
if an extended hose is required, please consult a
serviceman .
2 . The height of the drainage outlet must be 80-100
cm . Fix the drain hose to the clip at the back of the
washing machine to prevent it from dropping off .
Note: The drain hose should not be submerged in
water and should be securely fixed and leak-free . If the
drain hose is placed on the ground or if the pipe is at
a height of less than 80cm, the washing machine will
continuously drain while being filled (self-siphoning) .
cONNEctiNg tO thE pOWER SUppLY
Before connecting to the power supply, check:
¬ The socket is adequate for the maximum power of the Washer Dryer
(For safety, fuses in the power circuit should be rated for no less than 15A) .
¬ The voltage should meet the requirement .
¬ The power outlet should be capable of accepting the Washer Dryer plug .
¬ Connect the machine to an earthed socket outlet .
BEFORE USE
1.
1.
2.
2.