•
Change any items that should be unique, such as the Management Server IP address, through the
normal operation of the software.
To install the agent using the silent installation method:
Create a temporary directory.
1.
Copy the following files into the temporary directory you just created:
2.
DevManRA.ini—During an assisted install, this file is landed in the same folder in which the
o
agent is installed.
Setup.exe—This file is included with the installation files on the HP Infrastructure Management
o
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower).
Setup.iss—This file is included with the installation files on the HP Infrastructure Management
o
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower).
SetupRA.exe—This file is included with the installation files on the HP Infrastructure Management
o
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower).
From the directory that contains all four files, run Setup.exe /s /f DevManRA.ini to install
3.
silently.
If the .ini file is not located in the same folder as the Setup file, run Setup.exe /s /f <path>
DevManRA.ini, where <path> is the DevManRA.ini file location.
The following command line parameters can be specified and are applicable for both interactive and
silent modes.
Parameter
/s
/r
/f DevManRA.ini
Reconfiguring the agent on Windows operating
systems
To reconfigure the agent:
•
Right-click the agent system tray icon to display a context menu from which the management service
can be stopped or started. In this menu, you can also:
Launch a browser session using the Connect option.
o
Configure new settings using the Configure option.
o
Change the IP address or serial path that the agent uses for the management module.
o
Enable or disable a redundant configuration.
o
-or-
Function
Specifies a silent install.
Reboots the computer at completion of setup. This
option is supported only on Windows® and only
for a silent install.
Specifies a configuration .ini file used for clean
installs. When this option is specified, the device
detection and configuration step is omitted.
Installing the HP UPS Power Protection Agent 34