Advertisement
Quick Start Guide for DV-RW260H
Accessories
TV/VIDEO
Remote control unit
How to install the batteries
Use micro batteries type R-03 ("AAA" size, UM/SUM-4, HP-16 or similar).
Open the battery
compartment
cover in the
direction of the
arrow.
Connection
Disconnect all antenna wires from the rear of your TV and connect as follows.
Antenna-Input
VCR/DVD
AC power cord 240V/50 Hz
When you connect your equipment as shown in the diagram above, switch the TV to it's AV channel (this may
be labelled EXT / AUX etc.)
Two R-03 ("AAA" size,
UM/SUM-4, HP-16 or
similar) batteries for
the remote control unit
Install two
batteries (sup-
plied), paying
attention to the
polarity diagram in
the battery
compartment.
TV
To Scart socket
EXTERNAL Scart Socket (AV2)
Supplied Scart cable
Supplied Coaxial cable
21 pin scart cable
75 ohm coaxial cable
TV Scart socket (AV1)
1
Quick start guide
Replace the
compartment
cover.
Antenna
RF-Input (from house antenna)
RF-Output (to TV)
Advertisement
Related Manuals for Sharp DV-RW260H
Summary of Contents for Sharp DV-RW260H
- Page 1 Quick Start Guide for DV-RW260H Accessories Two R-03 (“AAA” size, TV/VIDEO UM/SUM-4, HP-16 or similar) batteries for 21 pin scart cable 75 ohm coaxial cable Quick start guide Remote control unit the remote control unit How to install the batteries Use micro batteries type R-03 (“AAA”...
-
Page 2: Setup Menu
Automatic TV tuning and clock setting Plug your unit into the mains supply and it will automatically start to tune itself in and set the correct date and time. When auto tuning is complete, you must switch the TV to it’s AV channel. AUTOMATIC SETUP IS ONLY AVAILABLE WHEN YOU PLUG THE UNIT IN FOR THE FIRST TIME. -
Page 3: Finalising A Disc
Read this before recording onto a disc You can use DVD-RW and DVD-R discs to record video. This unit has two modes for formatting discs for recording: VR mode and Video mode. VR mode • You cannot edit the recorded contents of a disc. •... -
Page 4: Dubbing A Tape Onto A Disc
Starting with an unused disc (automatic formatting) Only DVD-RW discs need to be formatted. 3. When formatting is complete, “FORMATTING COMPLETED 1. When you insert an unused PRESS ENTER” will appear. Press ENTER to finish NEW DISC FORMAT disc, the following mes- formatting process.