Setting Menu Items - Kenwood DDX4028BT Instruction Manual

Setting menu items

• You cannot change <Audio> settings (except <Preout Setup>) when the unit is in standby.
Menu item
Fader/Balance
Equalizer
Loudness
X'over
Volume Offset
Preout Setup *
2
Subwoofer *
Speaker Select
*
1
You can change the setting only when the unit is in standby.
*
2
Selectable only when <Subwoofer> is selected for <Preout Setup>.
38
DDX4028BT/DDX4058BT/DDX3028/DDX3058
Selectable setting/item
Fader : Adjust the front and rear speaker output balance.
♦ F6 to R6; Initial 0
• When using a two-speaker system, set the fader to the
center (0).
Balance : Adjust the left and right speaker output balance.
♦ L6 to R6; Initial 0
Press [ 5/∞/2/3 ] or drag [
• To clear the adjustment, press [Center].
Change the sound mode or adjust and store the equalization
for each source. (☞ page 31)
♦ Natural/Rock/Pops/Easy/Top40/Jazz/User
You can activate/deactivate the loudness function.
♦ OFF
♦ ON
Adjust the cross over frequency. (☞ page 32)
Adjust and store the auto-adjustment volume level for each
source. (For discs, the adjustment is stored for each of the
following categories: DVD/DVD-VR, VCD/CD, and DivX/
MPEG1/MPEG2/MP3/WMA/WAV/AAC.) The volume level will
automatically increase or decrease when you change the
source.
♦ –15 to +6; Initial 0
1
♦ Rear
♦ Subwoofer : Select this when subwoofer is connected
♦ ON
♦ OFF
Select the size of the connected speaker.
♦ Standard/Narrow/Middle/Wide
] to adjust.
: Cancels.
: Boost low and high frequencies to
produce a well-balanced sound at a low
volume level. The LOUD indicator lights up.
: Select this when rear speaker is connected
to REAR/SW jacks through an amplifier.
to REAR/SW jacks.
: Activates the subwoofer.
: Cancels.
Initial: Underlined