Controls And Functions; Front View - Mitsubishi Electric HS-MD3000E Installation And Operation Manual

Controls and Functions

Front View

EJECT button
Press to remove the cassette.
Cassette Loading Slot
Cassette is inserted in this slot for loading.
REW button
Press to rewind the tape.
STOP button
Press to stop all tape related functions. When pressing while
the tape is stopped or the tape is not loaded, the Counter display
on the fluorescent display will be changed to the clock. The
Counter display will automatically reappear after 5 seconds.
PLAY button
When the VCR is in stop mode, press to playback a previously
recorded tape.
FF button
Press to forward the tape.
REC button
Press this button and PLAY button at the same time to begin
recording. During playback, press to monitor the signal from
S-VIDEO/VIDEO IN and AUDIO IN L/R connector.
PAUSE button
During recording, press to stop the tape movement temporarily.
Press again to continue the recording.
During playback, press to obtain a still picture.
Fluorescent Display
page 4
POWER button
Press to turn the VCR POWER on or off.
Note
• When turning the VCR off during the tape is in operation
(fast forwarding, rewinding, playing or recording, etc.), press
STOP first to stop the tape and then press POWER to turn
off.
2
Introduction
EJECT
REW
COUNTER
RESET
POWER
MONITOR AUDIO KEY LOCK MIC
CH1 HiFi PART
MIX MIX OFF
CH2 NORMAL ALL
Symbol " ": on (power connection to the mains)
Symbol " ": off (power disconnection from the mains)
Note
JOG/ADJUST
STOP PLAY FF REC PAUSE
REV
FRAME/
SEARCH FIELD
MENU AUDIO DUB
CLEAR ENTER
TRACKING MARK IN
– +
PROGRAM A B
AUDIO switch
Use to select the audio signal output from the AUDIO OUT
CH-1/L and CH-2/R terminals on the rear panel.
connector
AUDIO OUT (CH-1/L)
AUDIO switch
setting
Hi-Fi Hi-Fi audio CH-1
MIX Both Hi-Fi audio CH-1
and normal audio
NORMAL normal audio
MONITOR switch
Use to select the audio signal output from the MONITOR
connector on the rear panel.
CH-1 : use to select audio signal from AUDIO OUT CH-1/L.
MIX : use to select audio signal from both AUDIO OUT CH-1/
L and CH-2/R.
CH-2 : use to select audio signal from AUDIO OUT CH-2/R.
KEY LOCK switch
Use to lock the VCR into the current mode.
PART : use to lock all buttons except STOP button, REC+PLAY
button, EJECT button, PAUSE button and POWER
button. "
OFF : use to release the lock.
ALL : use to lock all buttons except POWER button. "
illuminates on the fluorescent display.
COUNTER RESET button
Press to reset the counter to "0:00:00". Also, use to erase the
points memorized by MARK IN A/B buttons.
Note
• Press the button for about 2 seconds.
MIC IN jack
Input jack for a microphone. The audio signal from a
microphone is recorded to the normal audio channel.
MIC level indicator
During recording, illuminates according to the sound level.
A point to notice
SHUTTLE
FWD
AUDIO OUT (CH-2/R)
Hi-Fi audio CH-2
Both Hi-Fi audio CH-2
and normal audio
normal audio
" illuminates on the fluorescent display.
Supplementary information
Info.
"