Memory Function - Miele H 115 MB Operating Instructions Manual

You can delay the switching on of the
appliance by up to 23 hours and 59
minutes after starting a process.
Set the time of day before using auto-
matic pre-selection (refer to "Setting
the time of day") This makes the
start time easier to enter.
Enter a process.
Every operating mode and pro-
gramme can be pre-selected.
Press the touch control once be-
fore starting the programme.
The text/symbol for "Start time" will light
up in the display area.
The time of day will appear in the dis-
play area.
Enter the start time you require using
the + touch control.
If you should press the + touch control
for too long by mistake, use the – touch
control to correct the start time.
Begin the programme by pressing
the Start touch control.
38
The time of day will reappear in the dis-
play field. The text/symbol for "Start
time" will light up in the display field.
The stored entries will appear in the dis-
play area for selected settings. If the
automatic pre-selection option in the
Memory function has been chosen, the
entries for the M1 Programme will be
displayed.
Press the touch control at any time
and the start time will reappear in the
display area.
This will light up for approx. 4 seconds
and will then be replaced by the time of
day.
When the door is closed the oven com-
partment light is not switched on during
the pre-selection time. You can switch
the oven compartment light on for a
short while by pressing the Enter touch
control. The oven light will go off again
automatically after approx. 10 seconds.
If you press the Stop/C touch con-
trol during the pre-selection time,
the most recently selected micro-
wave power setting will appear in
the display area. If the automatic
pre-selection option in the Memory
function has been chosen, the
microwave power setting for M1 Pro-
gramme will be displayed. All other
entries are now cancelled.
If the door is open at the start time
then the process will be stopped.
The most recently selected micro-
wave power output level will appear
in the display area.