Time Display; Programme Sequence Indicators; At The End Of A Programme; Switching Off - Miele G 1252 SC Operating Instructions Manual

Operation

Time display

The duration of the programme
selected appears in hours and minutes
in the Time display before the
programme begins. During the
programme the time left until the end of
the programme is displayed.
The time displayed may vary with the
same programme. This can be due to
the water temperature at each intake,
the reactivation cycle and the amount
of crockery and how dirty it is.
To save energy the time display goes
out after a few minutes if you do not
press any buttons during this time.
Press any button (apart from the on/off
button) to switch the time display back
on again.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit adjusts the programme
duration according to the amount of
crockery and the temperature of the
incoming water.
To save energy, the time display
goes out after a few minutes if you do
not press any buttons during this
time. Press any button (except
ON/OF K) to switch the display back
on.
36
Programme sequence
indicators
After a programme has been started
the current stage of the programme is
indicated by the programme sequence
indicator lights.

At the end of a programme

A programme has finished when a "0"
appears in the Time display and the
"End" programme sequence indicator
lights up.
The dishwasher can now be opened
and unloaded (see "Unloading the
dishwasher").
,
To prevent the risk of steam
damage to the worktop edging
above the dishwasher, it is
advisable to leave the door closed
until you are ready to unload the
crockery. Alternatively you can open
the door fully until the crockery is
cool enough to unload. Do not leave
the door only partially open.

Switching off

At the end of a programme:
^ Switch the dishwasher off with the
On/Off button K.
The dishwasher will continue to use
electricity until it is switched off with
the On/Off button K.
If the dishwasher is not going to be
used for a longer period of time, e. g.
whilst on holiday, the stopcock should
be turned off.