Miele KFN 8996 SDE ed-1 Operating And Installation Manual page 41

. . . the alarm sounds, the
temperature display for the freezer
section is flashing, and §% is
flashing in the door display.
The freezer section temperature has
risen above the set temperature
because
^ the freezer section door has been
opened too frequently, or large
amounts of fresh food have been put
in at once for freezing.
^ the ventilation gaps are blocked.
^ there has been a lengthy interruption
to the power supply.
Once the problem has been resolved,
the freezer section temperature
indicator light will light up constantly
and the alarm will stop.
. . . a bar is lit up or flashing in the
temperature displays.
Check the temperature displays about
6 hours after switching on the
appliance. The display will not show a
temperature until the temperature in the
appliance has reached a certain level.
. . . one of the display areas in the
door display is not lit up.
This is not a fault. The relevant section
of the appliance is switched off.
. . . the door display does not light
up.
^ Check that the appliance is switched
on.
Problem solving guide
^ Check that the plug connector
between the appliance door and the
appliance is working properly:
– Disconnect the appliance from the
electricity supply.
– Open the door to the refrigerator
section.
– Remove the cover from the bearing
block.
– Check the plug connector.
– Refit the cover over the bearing
block.
– Reconnect the appliance to the
mains electricity supply.
If the appliance is switched on and the
plug connector is working properly, but
the door display is still not lit up, there
is a fault. Call the Service Department.
. . . "F1" to "F5" appear in the
temperature display.
There is a fault. Call the Service
Department.
. . . § appears in the door display.
There is a fault. Call the Service
Department.
41