Introduction; Safety Considerations; Initial Inspection; Operating Disk Installation - HP 16500A Service Manual

2-1. Introduction

This section contains information and instructions
necessary for setting up the HP 16500A/16501A
Logic Analysis System. This includes inspection
procedures, power requirements, hardware
connections and configurations, and packaging
information.

2-2. Safety Considerations

The safety symbols used with Hewlett-Packard
instruments are illustrated in the front of this
manual. WARNING and CAUTION symbols and
instructions should be reviewed before operating
the instrument. These warnings and cautions
must be followed for your own protection and to
avoid damage to the instrument.

2-3. Initial Inspection

Inspect the shipping container for damage. If the
shipping container or cushioning material is
damaged, it should be kept until the contents of
the shipment have been checked for
completeness and the instrument has been
checked mechanically and electrically. The
contents of the shipment should be as listed in
"Accessories Supplied" in section 1. If the
contents are incomplete, if there is mechanical
damage or defect, or if the instrument does not
operate properly, notify the nearest
Hewlett-Packard Sales Office. If the shipping
container is damaged, or the cushioning material
shows signs of stress, notify the carrier as well as
the Hewlett-Packard Sales Office. Keep the
shipping material for carrier's inspection. The
Hewlett-Packard Sales Office will arrange for
repair or replacement at Hewlett-Packard's option
without waiting for a claim settlement.
HP 16500A/16501A - Installation

2-4. Operating Disk Installation

The HP 16500A is shipped with yellow protective
disks in each disk drive. Before applying power to
the mainframe, remove the protective disks from
the front and rear disk drives, then install the
operating disk in one of the disk drives. Reinstall
the protective disks whenever the instrument is
transported.

2-5. Power Requirements

The HP 16500A and the HP 16501A each require
a power source of 115 Vac or 230 Vac, 48 to 66
Hz, 475 W maximum.

2-6. Line Voltage Selection

The instrument may be damaged if the Line
Voltage Select switch is not properly set.
When shipped from Hewlett-Packard, the Line
Select switch is set and an appropriate fuse is
installed for operating the instrument in the
country of destination.
SECTION II
Installation
2-1