Summary of Contents for Toshiba STRATA CIX DKT2404-UDR100
Page 1
TOSHIBA Telecommunication Systems Division DKT2404-UDR100 Repeater Operation Guide Title Page July 2009...
Page 2
To view the latest version of this or other documents please refer to the Toshiba FYI web site. Toshiba America Information Systems shall not be liable for any commercial losses, loss of revenues or...
Page 4
TAIS and which are not compatible or are of inferior quality, design, or performance. The sole obligation of TAIS or Toshiba Corporation under this warranty, or under any other legal obligation with respect to the equipment, is the repair or replacement of such defective or missing parts as are causing the malfunc- tion by TAIS or its authorized dealer with new or refurbished parts (at their option).
Important Electrical Considerations ....................13 FCC Regulatory Information ....................... 14 Part 15 Compliance ......................... 14 Privacy Information .......................... 14 Radio Interference Information ......................14 I.C. Notice ............................15 Terminal Equipment......................... 15 Radio Equipment ..........................15 TOSHIBA DKT2404-UDR100 Repeater 07/09 i of ii...
• Use an AC outlet not associated with computer or electromagnetic equipment. Refer to “Multiple Repeater Configuration” on page “Map the Base Station Coverage ” on page 9 “Installing the Repeater” on page TOSHIBA 2 of 16 DKT2404-UDR100 Repeater 04/09...
3. The repeater must be at least 35 feet (10 meters) from the base station. Use the mapping procedure (“Map the Base Station Coverage ” Page 9) to determine where to place repeaters. Figure 2 – Coverage with a Base Station and One Repeater TOSHIBA DKT2404-UDR100 Repeater 04/09 3 of 16...
Repeaters must be at least 35 feet (10 m) apart and the same minimum distance from the base station. Figure 3 – Overhead view of Multiple Repeater Coverage TOSHIBA 4 of 16 DKT2404-UDR100 Repeater 04/09...
Page 11
Repeaters can be daisy chained to increase the coverage area in one direction. Figure 4 – Daisy-chain Repeater Configuration The coverage area of the base stations and repeaters is spherical, it extends through walls, floors and ceilings. Figure 5 – Correct Repeater Placement TOSHIBA DKT2404-UDR100 Repeater 04/09 5 of 16...
Registration. This procedure requires the base station, a handset registered to that base station, and the repeaters to be registered. Before starting, label the repeaters. Assign a number (2 ~ 7) to each repeater. TOSHIBA DKT2404-UDR100 Repeater 04/09 7 of 16...
2. Reconnect the power for 1 to 5 seconds, and disconnect it again. 3. Reconnect the power for 25 to 35 seconds. 4. Disconnect the power, and register the repeater to the new base. TOSHIBA 8 of 16 DKT2404-UDR100 Repeater 04/09...
This lets you use the verification tone to map the coverage area of each repeater. When repeaters are daisy-chained the handset will receive one beep while connected to the first repeater area and two beeps while connected to the second repeater. TOSHIBA DKT2404-UDR100 Repeater 04/09 9 of 16...
1. Hold the repeater in its final location, and mark the center of the top edge. 2. From the edge mark, measure down about 1½ inches (approximately 38 mm), and mark the screw location. TOSHIBA 10 of 16 DKT2404-UDR100 Repeater 04/09...
Page 17
7. Put the repeater over the screw head and slide it down into place. 8. Plug the AC adapter to a 120 V AC power outlet. Figure 8 – DKT2404-DECT Repeater Rear View TOSHIBA DKT2404-UDR100 Repeater 04/09 11 of 16...
Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: • When the power supply cord is damaged or frayed. • If liquid has been spilled onto the product. TOSHIBA 12 of 16 DKT2404-UDR100 Repeater 04/09...
This repeater is no exception. Changes or modifications to this product not expressly approved by Toshiba America Information Systems, Inc., or operation of this product in any way other than as detailed by this manual, could void your authority to operate this product.
(You might even need to move the base unit.) When the situation persists, contact Customer Service. CAUTION! The base station must be placed at least 8 inches (20 cm) from nearby persons for compliance with FCC exposure guidelines. TOSHIBA 14 of 16 DKT2404-UDR100 Repeater 04/09...
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. “Privacy of communications may not be ensured when using this telephone.” TOSHIBA DKT2404-UDR100 Repeater 04/09 15 of 16...