Map The Base Station Coverage; Verification Tone - Toshiba STRATA CIX DKT2404-UDR100 Operation Manual

Map the Base Station
Coverage
Figure 7 – Mapping the Base Station Coverage Area

Verification Tone

DKT2404-UDR100 Repeater 04/09
Use this process to map the base station coverage area.
1. Stand near the base and make a call.
2. Continue the call, and carry the handset away from the base.
3. Make a note where you start to hear noise on the line, which indicates
the signal is getting weaker.
The optimum location for the repeater is as far from the base as possible
while still maintaining a good signal, or just inside the location where the
noise became noticeable.
The verification tone is a useful tool for troubleshooting installation
problems. When the verification tone is activated a handset beeps
whenever it moves into the coverage area of the repeater. The handset
will beep every few seconds as long as it is connected to the repeater.
This lets you use the verification tone to map the coverage area of each
repeater. When repeaters are daisy-chained the handset will receive one
beep while connected to the first repeater area and two beeps while
connected to the second repeater.
TOSHIBA
DKT2404-UDR100 DECT Repeater

Map the Base Station Coverage

9 of 16