Panasonic AJ-YAC960P Installation Manual page 5

SDTI Interface Board
9.
Disconnect the coaxial cable with the orange end from the SDI board, and connect it to the connector
located at the position on the SDTI board shown in the figure below.
10.
Follow the steps below to attach the SDTI board to the SDI board.
1 Position spacer 1 and spacer 2 at the holes on the SDI board.
2 Position spacer 3 at the hole on the SDI board.
Spacer 2
Spacer 1
Orange end
of cable
SDTI board
SDI board
Spacer 1
SDTI board
SDI board
E-4
Spacer 3
Spacer 2
Spacer 3