Changing Over The Freezer Compartment Door; Plug Socket - AEG SANTO 1450-8 TK Operating Instructions Manual

Installation

Changing over the freezer compartment door

1. Open the freezer compartment door a little
way.
2. Using a small screwdriver, press the spring in
the opening of the lower door bearing
slightly upwards and take the door bearing
out complete with the door.
3. Position the covering cap (M) on the
opposite side.
4. Turn the freezer compartment door
through 180° and fit the lower door
bearing into the lower bearing cavity
of the freezer compartment door.
5. Lift the freezer compartment door a
little way upwards, fit it into the upper
door bearing, and at the same time
insert the lower door bearing into the
square hole. Small upwards and downwards adjustments of the freezer
compartment door will make fitting easier.

Plug socket

The plug socket necessary for connection of your appliance to the
electricity supply should be positioned so that it is possible to pull out
the appliance plug.
If your appliance is installed under a
continuous worktop, the plug socket
should be provided as shown.
Alternatively a concealed spur socket
fitted with a 13 A fuse may be fitted.
If the socket is not accessible once
the appliance is built in, the electrical
installation must include suitable
means of isolating the appliance
10
M
AEG43
130
AEG44
300