AEG SANTO 1450-8 TK Operating Instructions Manual page 21

Symptom
The compressor runs con-
tinuously.
The food is too warm.
Interior lighting does not
work.
Heavy build up of frost,
possibly also on the door
seal.
Unusual noises.
The compressor does not
start immediately after
changing the temperature
setting.
Water in the bottom of
the cabinet.
Possible Cause
Temperature is set too
cold.
Temperature is not proper-
ly adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Light bulb is defective.
Door seal is not airtight
(possibly after reversing
the door).
Appliance is not level.
The appliance is touching
the wall or other objects.
This is normal, no error has
occurred.
Water drain hole is
blocked.
What to do if ...
Remedy
Turn the thermostat knob
to a warmer setting tem-
porarily.
Please look in the "Initial
Start Up" section.
Do not leave the door open
any longer than necessary.
Turn the thermostat knob
to a colder setting tem-
porarily.
Please look in the
"Installation location" section.
Please look in the "Changing
the Light Bulb" section.
Carefully warm the leaking
sections of the door seal
with a hair dryer (on a
cool setting). At the same
time shape the warmed
door seal by hand such
that it sits correctly.
Readjust the feet.
Move the appliance
slightly.
The compressor starts after
a period of time.
See the "Cleaning and
Care" section.
21