Installing Jumpers And Disconnecting The Intrusion Switches - NEC 455-01593-000 Installation Manual

Installing Jumpers and Disconnecting the Intrusion Switches

To disconnect the intrusion switches and install the two new jumpers perform
the following procedures.
1. Remove the cable from connector J5 on the SCSI backplane (see the
following figure). The cable will be reconnected when installing the
Interlock Switches later in this Guide.
Unplugging the Intrusion Switches on the SCSI Backplane
2. Install the two jumpers supplied with your kit onto connector J5 on the SCSI
backplane (see the following figure).
Installing Jumpers on the SCSI Backplane
Redundant Power Upgrade Kit Installation Procedures 13