Table of Contents
Advertisement
Removing the Power Supply Retaining Bracket
1. Power off the system and unplug the power supply ac power cable.
2. Remove the right side panel and standard power supply (if not already
removed) as described earlier.
3. Remove the screw (see figure below) that secures the power supply retaining
bracket to the chassis.
4. Remove the power supply retaining bracket from the chassis.
Note: T
needed.
Removing the Power Supply Retaining Bracket
Removing the Power Supply Blank Mounting Plate
1. Power off the system and unplug the power supply ac power cable.
2. Loosen the three thumbscrews (see A in figure below) that secure the power
supply blank mounting plate (B) to the rear panel.
3. Remove the power supply blank mounting plate (B) from the rear of the
chassis.
Note: T
longer needed.
8 Redundant Power Upgrade Kit Installation Procedures
he power supply retaining bracket is no longer
he power supply blank mounting plate is no
Advertisement
Table of Contents
