Installing The Usb Driver (Windows 98) - Sharp AJ-2100 Operation Manual

INSTALLING THE USB DRIVER (Windows 98)

If the printer is connected to your computer by USB cable, you have to install the USB driver
before installing the printer driver. To install the USB driver, follow the steps shown below.
Make sure that the printer is connected to your computer by
1
USB cable.
Turn on the printer, and then turn on your computer.
2
"Add New Hardware Wizard" window will appear. If this window does not appear,
refer to "Failed to Install the Printer Driver (USB Interface)" in "Troubleshooting" of
the online manual.
Click the "Next" button.
3
Check the radio button for "Search for the best driver for your
4
device (recommended)", and then click the "Next" button.
Insert the supplied CD-ROM into your CD-ROM drive.
5
Select the "Specify a location:", type "D:\ENGLISH\WIN9X\USB",
6
and then click the "Next" button.
(Change "D" to correspond to the letter of your CD-ROM drive.)
Click the "Next" button.
7
Click the "Finish" button.
8
You have completed the installation of the USB driver.
After installing the USB driver, the "Add Printer Wizard" will appear. Move on to the
step 6 of "Installing onto Windows 95 / 98" (page 26).
The USB driver will remain in your system even after uninstalling the printer driver.
21