Figure 8. Virtual Disk Management
Figure 9. Selecting Bootable Virtual Disk (VD)
7.
Select Ctrl Mgmt, click Select bootable VD, and select VD 0 as the VD0 RAID1.
8.
Click Apply, and reboot the DR Series system.
The RM Recover My Appliance mode process will then complete.
Hardware Removal or Replacement
To properly remove or replace any DR Series system hardware, you must observe and use the best practice shut down
and start up procedures. For a comprehensive set of removal and replacement procedures with step-by-step
Dell DR Series System Owner's Manual .
instructions, see the
For more information about the best practices, see
Down the DR Series
System.
124
DR Series System: Proper Shut Down and Start Up
and
Shutting