Hitachi C18DLP4 - 18V Li-Ion 6-1/2" Circular Saw Safety Instructions And Instruction Manual page 14

English
If the "switch lock" is pulled in a state where it is
pressed in the direction of the arrow mark, the
main switch can be turned ON.
(1) Switch lock is used as the "light switch". If the
"switch lock (light switch)" is pulled in a state, the
light is turned ON.
(2) After the switch is turned ON, even when you
release your hand from the switch lock, the body
continues running and the light continues being
turned ON as long as you keep on pulling the
switch trigger.
(3) If you release the switch trigger, you can turn OFF
the switch and the "switch lock" returns to the
original position automatically and the light turns
OFF too.
Switch lock
* (It works as
switch lock
alone if the
machine is
not
equipped
with light.)
2. Working performance per single charge (Reference
data)
Cutting capability differs according to the condition
of lumber, type of saw blade, ambient temperature,
battery characteristics, etc.
Wood
2 × 8 (Spruce-Pine-Fir)
Concreteform plywood
(1/2" (12 mm) t)
To improve working efficiency per single charge,
Minimize operation (no-load operation) other than
cutting;
Avoid any unreasonably forced pressure to the
motor during cutting operation by twisting or
pressing the circular saw forcibly;
Avoid any use of dull saw blade.
3. Cutting procedures
CAUTION:
Recheck that the saw blade is securely clamped.
Confirm that the wing-nut for adjusting the slot
depth, the wing-bolt for adjusting the angle of
inclination.
(1) Place the base on the material, then align the
premarked line and the saw blade with the notch
at the front of the base (Fig. 12).
14
Switch trigger
Fig. 11
Capacity
Battery (EBM1830) Battery (BCL1815)
110 cuts 55 cuts
133 ft (40 m) 67 ft (20 m)
(2) When the base is not inclined, use the large notch
(Fig. 12, Fig. 13).
If the base is inclined (45 degrees), use the small
notch (Fig. 12, Fig. 14).
Not inclined
Saw blade
Fig. 12 <Top View>
Wing-bolt
Fig. 13 Not inclined
Inclined
gauge
Wing-bolt
Guide
Cutting line
(at 45 degrees)
Fig. 14