Event Log
Displays the
Configuration
Peripheral Configuration Submenu
Option
Function
USB Controller
Sets the USB controller to either Enabled (default) or Disabled.
Legacy USB Support
Set to Disabled if legacy USB support is not desired. Enabled (default) allows support for legacy USB.
Integrated Audio
Sets the integrated audio controller to either Enabled (default) or Disabled.
Integrated Network Adapter Sets the integrated network controller to either Enabled (default) or Disabled.
Serial Port
Sets the integrated serial port setting to Auto, (default) 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, 3F8/IRQ4, or Disabled.
Parallel Port
Sets the integrated parallel port setting to Auto, (default) 3BC/IRQ7, 278/IRQ5, 378/IRQ7, or Disabled.
Parallel Port Mode
Sets the integrated parallel port mode to Bi-directional (default), Output Only, ECP, or EPP.
ECP Mode Use DMA
If the Parallel Port Mode option is set to ECP, this setting selects the ECP DMA mode. The options are 3 (default) and 1.
IDE Configuration Submenu
Option
Function
Primary IDE
Configures the integrated primary IDE controller as either Enabled (default) or Disabled.
Controller
Secondary IDE
Configures the integrated secondary IDE controller as either Enabled (default) or Disabled.
Controller
IDE Drive UDMA
Set IDE Drive UDMA mode as either Enabled (default) or Disabled.
IDE Primary Master
Identifies the first drive attached to the primary IDE interface, usually the boot hard drive. See
Event Log Configuration
submenu.
"IDE Primary Master
Submenu."