IDE Primary Slave
Identifies the second drive attached to the primary IDE interface, usually a second hard drive. The format of this submenu is the same
as the one described in
IDE Secondary
Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the one
Master
described in
IDE Secondary Slave Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the one
described in
IDE Primary Master Submenu
Option
IDE HDD Auto-Detection
IDE Primary Master
Capacity
Cylinder, Head, Precoup, Landing Zone,
Sector
Access Mode
PIO Mode
UDMA Mode
Diskette Configuration Submenu
Option
Function
Diskette Controller
Configures the floppy drive interface. Options are Enabled (default) and Disabled.
Drive A:
Selects the floppy drive type as 1.44M, 3.5 in (default); None; 360K, 5.25 in; 1.2M, 5.25 in; 720K, 3.5 in; or 2.88M, 3.5 in.
Floppy 3 Mode
Selects Floppy 3 mode support for the floppy drive. Options are Disabled (default) and Drive A.
Support
"IDE Primary Master
Submenu."
"IDE Primary Master
Submenu."
"IDE Primary Master
Submenu."
Function
Press <Enter> to start auto-detection for the primary IDE hard drive.
Specifies the type of hard drive. Settings for this option are Auto (default), None, and Manual.
Displays the maximum capacity of the primary IDE device.
Displays each setting of the primary IDE device.
Sets the access mode of the primary IDE device. The options are Auto (default), CHS, LBA, and Large.
Sets the PIO mode of the primary IDE device. The options are Auto (default), Mode 0, Mode 1, Mode 2, Mode 3,
and Mode 4.
Sets the ultra DMA setting of the primary IDE device as either Auto (default) or Disabled.