Wireless Security - Dell TrueMobile 2300 User Manual

When you configure the Wireless Broadband Router, you must set the wireless parameters listed below. If you are adding the
Wireless Broadband Router to an existing wireless network, see your network administrator or the person who initially set up
the wireless network. If you are unfamiliar with the wireless settings, see the descriptions below.
NOTE: You must change each client's wireless adapter settings to match the Wireless Broadband Router settings.
Use the factory defaults for the Wireless Broadband Router, unless the default settings have been changed. In this
case, note the changes, and use the new settings for each wireless network card. For assistance configuring a
wireless network card, see the card's documentation.
Network Name (SSID)
Channel
Network Name (SSID)
The network name is a value that identifies a collection of wireless devices found in a particular network. The default value for
the Wireless Broadband Router is "wireless". All workstations and access points must use the same SSID to be able to
communicate with one another.
The SSID is a 32-character field, and the value is case sensitive. For example, your street address or some other identifier of
the physical location of the WLAN, your name, your company name, or the company name and department, a favorite slogan
or saying, etc.
Channel
The Wireless Broadband Router can operate on a variety of channels. Units within close proximity to one another must be on
different channels. If you have just one unit, then the default, channel 6, is probably adequate. If you have multiple access
points in your network, it is suggested to stagger the channels for each unit. It is advisable to use the default unless there is a
specific reason for changing the channel such as interference from microwaves, cellular phone towers, or other access points in
the area.
Click NEXT to continue.
Back to Top

Wireless Security

Data encryption provides added security by encoding network communications using an encryption key. Your Wireless
Broadband Router, in conjunction with wireless network adapters that support encryption, can scramble your transmitted data to
make it very difficult for someone to eavesdrop or intercept your information. Two methods of data encryption are available:
WEP and WAP. If you wish to enable wireless security, check the Enable Wireless Security box.
WEP
If you wish to enable WEP encryption, select WEP in the Network Authentication list.
Setting
Key Format
Key Length
Key1, Key2, Key3, Key4
There are two levels of WEP encryption: 40(64)-bit and 104(128)-bit, with 104(128)-bit being the more secure. The WEP
Setting
Hexadecimal Digits / ASCII Characters
40 bits (5 characters) / 104bits (13 characters)
<user-defined>
Possible Values
(wireless by default)
(6 by default)
Possible Values