Fujitsu BX600 User Manual page 52

Message
Number
7
8
9
10
11
12
13
14
15
16
152
Message
Network controller
configured for 10Mb full-
duplex link.
Network controller
configured for 100Mb
half-duplex link.
Network controller
configured for 100Mb
full-duplex link.
Network controller
configured for 1Gb half-
duplex link.
Network controller
configured for 1Gb full-
duplex link.
Medium not supported.
Unable to register the
interrupt service routine.
Unable to map IO space.
Driver initialized
successfully.
NDIS is resetting the
miniport driver.
Cause
The adapter has been
manually configured for
the selected line speed and
duplex settings.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
The adapter has been
manually configured for
the selected line speed and
duplex settings.
The operating system does
not support the IEEE
802.3 medium.
The device driver cannot
install the interrupt
handler.
The device driver cannot
allocate memory-mapped
I/O to access driver
registers.
The driver has
successfully loaded.
The NDIS layer has
detected a problem
sending/receiving packets
and is resetting the driver
to resolve the problem.
Corrective Action
Informational message
only.
No action is required.
Informational message
only.
No action is required.
Informational message
only.
No action is required.
Informational message
only.
No action is required.
Informational message
only.
No action is required.
Reboot the operating
system, run a virus check,
run a disk check (chkdsk),
and reinstall the operating
system.
Reboot the operating
system; remove other
device drivers that may be
sharing the same IRQ.
Remove other adapters
from the system, reduce
the amount of physical
memory installed, and
replace the adapter.
Informational message
only.
No action is required.
Run BACS2 diagnostics;
check that the network
cable is good.